The Optimization of Machining Operations Based on Non-Quadratic Model Via Sumt
الشريط الجانبي للمقالة
محتوى المقالة الرئيسي
الملخص
The need for higher production rates and lower production cost emphasized the need to increase the rate of metal removal on metal cutting machine tools. This is however, limited by the different technical and technological constraints of the machining process so that the problem has to be handled as an optimization to determining the optimum values of the machining parameters. Several optimization techniques have been developed to solve this problem such as linear and non linear programming methods. However, due to the complexity of the mathematical models and the relatively large number of constraints involved, there is no obvious solution. This paper introduces a developed algorithm and compared to one of the well known iteration method that is the Sequential Unconstrained Minimization Technique (SUMT). The comparison through an example problem shows that the developed algorithm is more efficient, accurate, as well as quicker the optimum solution.
المقاييس
تفاصيل المقالة
هذا العمل مرخص بموجب Creative Commons Attribution 4.0 International License.
THIS IS AN OPEN ACCESS ARTICLE UNDER THE CC BY LICENSE http://creativecommons.org/licenses/by/4.0/
##plugins.generic.plaudit.displayName##
المراجع
Ostwald, P. F.;” Cost estimating”, 2nd ed., Prentice-Hall Inc., Englewood Cliffs, New Jersey,(1984).
Cowton, C.J. and Wirth, A.;” On the economics of cutting tools “, Int. J. Prod. Res., Vol. 31, No. 10,(1993), PP. 2441-2446. DOI: https://doi.org/10.1080/00207549308956867
Opas, J.; Kanerva, F.; and Mautyal, M.;” Automatic process plan generation in an operative process planning system”, Int. J. Prod. Res. Vol. 32, No. 6, (1994), PP. 1347-1363. DOI: https://doi.org/10.1080/00207549408957004
Koulamas, C.;” Operation sequencing and machining economics”, Int. J. Prod. Res., Vol. 31, No. 4, (1993), PP. 957-975. DOI: https://doi.org/10.1080/00207549308956769
El-Hakim, M.A; El-Awan, A. M; and El-Sabbage, A.S.;” A computer program of the optimization of machining variables”,Computer and Indus. Eng., Vol. 7, No. 4, (1983), PP. 317-336. DOI: https://doi.org/10.1016/0360-8352(83)90015-3
Agapiou, J.S.;” The optimization of machining operations: The use of a combined objectives in single-pass operation”, ASME J. Eng.For Industry, Vol. 114, Nov. (1992), PP. 500-513. DOI: https://doi.org/10.1115/1.2900704
Saleh, S.A. “ Computer Aided Process Planning using Developed Economic Criteria”, Ph.D. Thesis University of Technology,Baghdad, Iraq (1996).
Saleh, S.A.; Al-Assady, N.H.; and Adil, M.B.;” ConstrainedMinimization Technique Based on Non- Quadratic Model”, DirasatJ. Natural and Eng Sci., Vol. 25, Feb. (1998), PP. 1-12.
Bunday, B.D.;” Basic optimization methods”, Edward Arnold Pub.Ltd., London (1985).
Edgar, T. F., and Himmelblau, D. M.;” Optimization of chemical process”, McGraw-Hill , Inc. New York (1988).