Evaluating the Predicted Shear Strength of Concrete Deep Beams Reinforced with FRP Bars with/without Fibrous Concrete
الشريط الجانبي للمقالة
محتوى المقالة الرئيسي
الملخص
One of the typical and significant components of large structural superstructures, such as offshore structures, bridges, and large multistory buildings, is the reinforced concrete deep beam. A deep beam is mostly used to transfer load foundations, girders, bending and pile caps, and some walls. Numerous studies have been done on the deep beams’ behavior under stresses because of the significance of deep beams. Even there are specifications for fiber-reinforced Polymers (FRP) reinforced deep beam in some codes, along with suggestions for the method prediction of load failure, strut-tie method (STM) method, included in most codes. It should be noted that many studies are still re-evaluating the factors utilized in the analysis method. The paper offers deep beam analysis methods of the shear models proposed by the codes and searcher for some published research. The survey database of 120 FRP-reinforced deep beams tested in shear was used to conduct the study. All specimens simply supported beams under three or four points load and rectangular cross-section. The specimens studied included different web shear reinforcement (horizontal and vertical), compressive strength, shear span-to-depth ratio a/d, and fiber volume fraction. Models combining steel and FRP reinforcement were excluded. The models predicting the shear capacity of FRP reinforced deep beams evaluated in this study were STM of CSA S806-12, Shear capacity V_c of ACI 440-11-22 and CSA S806-12, Zhang et al. [31] model, and Nehdi et al. [32] model. The models predicting the shear capacity of FRP reinforced deep beam evaluated in this study were either unsafe or inaccurate. The shear strength prediction of STM CSA S806 was most appropriate; however, it is conservative, making it uneconomical. Zhang et al. [31] presented a shear strength prediction model for FRP-reinforced deep beams without web reinforcement. No method is recommended for calculating the effect of fiber volume fraction on the shear capacity of FRP-reinforced concrete deep beams.
المقاييس
تفاصيل المقالة
هذا العمل مرخص بموجب Creative Commons Attribution 4.0 International License.
THIS IS AN OPEN ACCESS ARTICLE UNDER THE CC BY LICENSE http://creativecommons.org/licenses/by/4.0/
##plugins.generic.plaudit.displayName##
المراجع
ACI Committee 318, Building Code Requirements for Structural Concrete (ACI 318-19) and Commentary (ACI 318R-19), American Concrete Institute, Farmington Hills, MI, 2019.
El-Sayed AK, Shuraim AB. Size Effect on Shear Resistance of High Strength Concrete Deep Beams. Materials and Structures 2016; 49(5): 1871-1882. DOI: https://doi.org/10.1617/s11527-015-0619-1
Nawy EG. Reinforced Concrete: A Fundamental Approach. 2nd ed., Boca Raton: CRC Press; 2008.
Ebrahim AE, Elmeligy OM, El-Metwally SE, Ghoneim MA, Askar HS. Refined Strength Prediction of Concrete 2D Bottle-Shaped Struts. Journal of Structural Engineering 2021; 4(2):111-125. DOI: https://doi.org/10.31462/jseam.2020.04111125
Bairán JM, Menduiña R, Marí A, Cladera A. Shear Strength of Non-Slender Reinforced Concrete Beams. ACI Structural Journal 2020; 117 (2): 277-289. DOI: https://doi.org/10.14359/51721369
Kong FK. Reinforced Concrete Deep Beams. 1st ed., London: Blackie and Son Ltd.; 1991. DOI: https://doi.org/10.4324/9780203034880
El Zareef MA, Elbisy MS, Badawi M. Evaluation of Code Provisions Predicting, the Concrete Shear Strength of FRP-Reinforced Members without Shear Reinforcement. Composite Structures 2021; 275: 114430. DOI: https://doi.org/10.1016/j.compstruct.2021.114430
Chen H, Yi WJ, Ma ZJ, Hwang HJ. Modeling of Shear Mechanisms and Strength of Concrete Deep Beams Reinforced with FRP Bars. Composite Structures 2020; 234: 111715. DOI: https://doi.org/10.1016/j.compstruct.2019.111715
ACI Committee. ACI 440.1R-15: Guide for The Design and Construction of Structural Concrete Reinforced with FRP Bars. American Concrete Institute, Farmington Hills, 2015.
ACI Committee 440. Building Code Requirements for Structural Concrete Reinforced with Glass Fiber-Reinforced Polymer (GFRP) Bars-Code and Commentary. ACI 440.11.22. American Concrete Institute, Farmington Hills, MI, 2022.
CSA Standard S806-12. Design and Construction of Building Components with Fiber-Reinforced Polymers. (CSA) Canadian Standards Association, 2012.
CSA Standard - A23.3-19: Design of Concrete Structures Canadian Standards Association. (CSA) Canadian Standards Association, 2019.
Latosh FA. Structural Behaviour of Conventional and FRP-Reinforced Concrete Deep Beams. PhD Thesis. Concordia University; Montréal, Québec, Canada: 2014.
Said M, Adam MA, Shanour AS. Experimental and Analytical Shear Evaluation of Concrete Beams Reinforced with Glass Fiber Reinforced Polymers Bars. Construction and Building Materials 2016; 102: 574-591. DOI: https://doi.org/10.1016/j.conbuildmat.2015.10.185
Mohamed K, Farghaly AS, Benmokrane B. Effect of Vertical and Horizontal Web Reinforcement on the Strength and Deformation of Concrete Deep Beams Reinforced with GFRP Bars. Journal of Structural Engineering 2017; 143 (8): 04017079. DOI: https://doi.org/10.1061/(ASCE)ST.1943-541X.0001786
Nassif MK, Erfan AM, Fadel OT, El-sayed TA. Flexural Behavior of High Strength Concrete Deep Beams Reinforced with GFRP Bars. Case Studies in Construction Materials 2021; 15: e00613. DOI: https://doi.org/10.1016/j.cscm.2021.e00613
El-Sayed AK, El-Salakawy EF, Benmokrane B. Shear Strength of Fiber-Reinforced Polymer Reinforced Concrete Deep Beams Without Web Reinforcement. Canadian Journal of Civil Engineering 2012; 39(5): 546–555. DOI: https://doi.org/10.1139/l2012-034
Farghaly AS, Benmokrane B. Shear Behavior of FRP-Reinforced Concrete Deep Beams without Web Reinforcement. Journal of Composite for Construction 2013; 17 (6): 04013015. DOI: https://doi.org/10.1061/(ASCE)CC.1943-5614.0000385
Abed F, El-Chabib H, AlHamaydeh M. Shear Characteristics of GFRP-Reinforced Concrete Deep Beams Without Web Reinforcement. Journal of Reinforced Plastics and Composites 2012; 31(16): 1063-1073. DOI: https://doi.org/10.1177/0731684412450350
Kim DJ, Lee J, Lee YH. Effectiveness Factor of Strut-and-Tie Model for Concrete Deep Beams Reinforced with FRP Rebars. Composites Part B: Engineering 2014; 56: 117-125. DOI: https://doi.org/10.1016/j.compositesb.2013.08.009
Andermatt MF, Lubell AS. Behavior of Concrete Deep Beams Reinforced with Internal Fiber-Reinforced Polymer-Experimental Study. ACI Structural Journal 2013; 110 (4): 585-594. DOI: https://doi.org/10.14359/51685744
Bediwy A, Mahmoud K, El-Salakawy E. Structural Behavior of FRCC Layered Deep Beams Reinforced with GFRP Headed-End Bars. Engineering Structures 2021; 243: 112648. DOI: https://doi.org/10.1016/j.engstruct.2021.112648
Hosseini SA, Nematzadeh M, Chastre C. Prediction of Shear Behavior of Steel Fiber-Reinforced Rubberized Concrete Beams Reinforced with Glass Fiber-Reinforced Polymer (GFRP) Bars. Composite Structures 2021; 256: 113010. DOI: https://doi.org/10.1016/j.compstruct.2020.113010
Thomas J, Ramadass S. Improved Empirical Model for the Strut Efficiency Factor and the Stiffness Degradation Coefficient for the Strength and the Deflection Prediction of FRP RC Deep Beams. Structures 2021; 29: 2044-2066. DOI: https://doi.org/10.1016/j.istruc.2020.12.039
Liu HX, Yang JW, Wang XZ, Han DJ. Experimental Study on Shear Behavior of BFRP-Reinforced Recycled Aggregate Concrete Deep Beams without Stirrups. KSCE Journal of Civil Engineering 2017; 21(6): 2289-2299. DOI: https://doi.org/10.1007/s12205-016-1081-5
Alhamad S, Al Banna Y, Al Osman A, Mouthassseeb J, Abdalla S, Abed F. Effect of Shear Span-to-Depth ratio on the Shear Behavior of BFRP-RC Deep Beams. MATEC Web of Conferences 2017; 120: 01012, (1-7). DOI: https://doi.org/10.1051/matecconf/201712001012
Abed F, Sabbagh MK, Karzad AS. Effect of Basalt Microfibers on the Shear Response of Short Concrete Beams Reinforced with BFRP Bars. Composite Structures 2021; 269: 114029. DOI: https://doi.org/10.1016/j.compstruct.2021.114029
Darwin D, Dolan CW, Nilson AH. Design of Concrete Structures. 15th ed., New York, USA: McGraw-Hill Education; 2016.
ACI Committee 445. Strut-and-Tie Method Guidelines for ACI 318-19-Guide. ACI-ASCE Committee PRC-445.2-21. (ACI) American Concrete Institute, 2021.
Schlaich J, Schafer K. Design and Detailing of Structural Concrete Using Strut-and-Tie Models. Structural Engineering 1991; 69(6): 113-125.
Zhang T, Oehlers DJ, Visintin P. Shear Strength of FRP RC Beams and One-Way Slabs without Stirrups. Journal of Composites for Construction 2014; 18 (5): 04014007. DOI: https://doi.org/10.1061/(ASCE)CC.1943-5614.0000469
Nehdi M, El Chabib H, Saïd AA. Proposed Shear Design Equations for FRP-Reinforced Concrete Beams Based on Genetic Algorithms Approach. Journal of Materials in Civil Engineering 2007; 19 (12): 1033-1042. DOI: https://doi.org/10.1061/(ASCE)0899-1561(2007)19:12(1033)
Wight JK, McGregor JG. Reinforced Concrete Mechanics and Design. 7th ed. New Jersey: Person; 2012.
Tan KH, Cheng GH. Size Effect on Shear Strength of Deep Beams: Investigating with Strut-and-Tie Model. Journal of Structural Engineering 2006; 132 (5): 673-685. DOI: https://doi.org/10.1061/(ASCE)0733-9445(2006)132:5(673)