vol23no3pa7

References

[1] Katkhuda, H. and Dwairi, H., “Assessment of the Buckling Behavior of Square Composite Plates with Circular Cutout Subjected to In-Plane Shear”, Jordan Journal of Civil Engineering, 3(2):184-195, 2009.
[2] Pannok, R. and Singhatanadgid, P., “Buckling Analysis of Composite Laminate Rectangular and Skew Plates with Various Edge Support Conditions”, The 20th Conference of Mechanical Engineering Network of Thailand, 2006.
[3] Supasak, C. and Singhatanadgid, P. A., “Comparison of Experimental Buckling Load of Rectangular Plates Determined from Various Measurement Method”, The 18th Conference of Mechanical Engineering Network of Thailand; 2002.
[4] Fok, “Applied Theory of Thin Plates to Engineering Structures”,1984.
[5] Niu, M. C. Y., “Airframe Stress Analysis and Sizing”, 2nd ed. Hong Kong Conmilit Press Ltd, Hong Kong. Chapter 13, 2001.

Tikrit Journal of Engineering Sciences (2016) 23(3) 63- 70

An Experimental Study of Circular Cutout Hole Effect of Kevlar/epoxy-Al2O3 Composite under Subjected to Quasi-Static Compressive and Tensile Loading

Ayad Abed Ramadhan
Dept. of Mechanical Techniques, Al-Hawija Technical Institute, Northern Technical University, Iraq

Abstract

This paper has presented an experimental study of quasi-static compressive and tensile loading of cutout hole on multi-layer of Kevlar-29/epoxy-Al2O3laminated composite. The experimental procedure has been developed to study the performance of (50%, 55% and 60%) volume fraction (vf) and (0o/90o and +45o/-45o) fiber orientation angle effects of these composites under quasi-static compressive and tensile load using a servo-hydraulic testing machine. It was concluded that the maximum load bearing capacity increases as volume fraction increases in tensile test. While, the maximum load bearing capacity increases with the decrease of volume fraction in compression test. Hence, from the results obtained it can considered the 55% volume fraction of composite panels is a good value for tensile and compression applications

Download Full-Text PDF

Keywords: Experimental study, Cutout, Composite materials and Tensile and compressive load.

How to cite

TJES: Ramadhan AA. An Experimental Study of Circular Cutout Hole Effect of Kevlar/epoxy-Al2O3 Composite under Subjected to Quasi-Static Compressive and Tensile Loading. Tikrit Journal of Engineering Sciences 2016; 23 (3):63-70.
APA: Ramadhan, A. A. (2016). An Experimental Study of Circular Cutout Hole Effect of Kevlar/epoxy-Al2O3 Composite under Subjected to Quasi-Static Compressive and Tensile Loading. Tikrit Journal of Engineering Sciences, 23(3), 63-70.