Hartmann T., ”Steel Fiber Reinforced Concrete”, Department of Structural Engineering Royal Institute of Technology, Stockholm, April-May 1999, pp.1- 44.
ACI Committee 544, ”Guide for Specifying , proportioning, Mixing, placing, and Finishing Steel Fiber Reinforced Concrete”, ACI Journal, Vol. 81, May, 1993, pp.140-148.
Romualdi, J.P. and Baston, G.B., “The behavior of reinforced concrete beams with closely spaced reinforcement”, ACI Journal, Proceeding, Vol.60, No.6, June 1963, pp.775-789.
 Romualdi, J.P. and Mandel, J.A.” Tensile strength of concrete affected by uniformly distributed and closely spaced short lengths of wire reinforcement”, ACI, Journal, Proceeding, Vol.61, No.6, June 1964, pp. 657-671.
Tikrit Journal of Engineering Sciences (2008) 15(2) 37-46
Effect of Repeated Loads on Modulus of Elasticity for Fiber Reinforced Concrete
|Salwa Mubark Abdullah|
|Civil Eng. Dept.-University of Mousl,Iraq.|
In this research the effect of repeated loads on the initial modulus of elasticity for the fiber reinforced concrete was studied by casting six standard cylinders specimen (150*300mm) for every ratio of fiber, three volume ratios of steel fiber (0,0.4,0.8,1.2)%,were used after 28 days the specimen was tested choosing mix with water cement ratio that gives slump about (80-100) mm. The modulus of elasticity for fiber reinforced concrete cylinders at 28 days for the same ratio were tested by applying load on the three specimens until failure. The other specimens was studied under loads ratio (50%, 60%,75%) from the ultimate load under 25 repeated load then the stress-strain curve was found until load failure. The modulus of elasticity was calculated from the linear part of the stress-strain relationship.
Keywords: Fiber Reinforced Concrete, Modulus of Elasticity, Repeated Load.